What are you looking for?

This is Search input need to add more information.


The Model UBP-10 bi-polar in-line amplifier supplies a highly-regulated, bridge excitation voltage for the transducer and converts the millivolt signal of the transducer to a ±10 Vdc signal. (-)OUTPUT is biased approximately 1/3 of the supply voltage. The output will swing 0 Vdc to 10 Vdc around the (-)OUTPUT reference voltage. The universal, in-line amplifier features three selectable excitation voltages, programmable gain settings, wide adjustment range on the zero and a buffered solid-state shunt cal relay for quick calibration.


  • For replacement only, not to be used in new design
  • Strain gage sensor amplifier
  • ±5 Vdc output
  • ±15 Vdc supply voltage
  • NEMA 4 housing
  • Selectable excitation voltages: 3 V, 5 V, or 10 V @ 70 mA
  • Increases signal-to-noise ratio in noisy environments
  • Effects of voltage drops in excitation sources are eliminated
  • Signals may be sent to the data systems from low impedence sources
UBP-10 Plastic or Die-Cast Amplifiers – Honeywell


Model UBP Universal Bi-Polar In-Line Amplifier Datasheet Datasheet English 240KB
Model UBP-10 In-Line Transducer Product Manual Installation Instructions English 406KB
Model UBP-10 Front View Photo English 59KB
Model UBP-10 Bottom View Photo English 86KB
Model UBP-10 Top View Photo English 80KB
Instrumentation Accessories Datasheet Datasheet English 641KB

Browse UBP-10 Series Products

Product Case Material Number of Channels Input Type
060-6827-01 Plastic or Painted Aluminum 1 ±15 Vdc input
060-6827-06 Plastic or Painted Aluminum 1 24 Vdc to 32 Vdc single voltage supply input


Social Media

Site Information


Terms & Conditions

Global Unsubscribe

Copyright © 2020 Honeywell International Inc.