Honeywell’s full line of subminiature pressure transducers accurately measure pressure ranges from 150 psi to 20000 psi. These gage-only subminiature pressure transducers have a high natural frequency and utilize a flush diaphragm that is manufactured from 17-4 PH Stainless Steel. Temperature compensation is accomplished by using temperature-sensitive components located inside the transducers.
These transducers have a small electrical zero balance circuit board which is in the lead wire (approximately 1 in x 0.087 in thick). This balance board does not have to be in the same temperature as the transducers. All transducers have four (4) active bonded strain gages arranged in a Wheatstone-bridge configuration.Most are manfuactured with a unitized stainless steel diaphragm. The advantage of this type of design is that a thin diaphragm and heavy sidewalls are made from one piece of stainless steel. This unitized diaphragm is rugged, but at the same time it is thin enough to measure low pressures.
|Model G Pressure Transducer Datasheet||Datasheet||English||228KB|
|Pressure Accessories Datasheet||Datasheet||English||374KB|
|Model G External Wiring Diagram||Technical Information||English||16KB|
|Model G Installation Drawing||Technical Information||English||137KB|
|Model G Front View||Photo||English||79KB|
|Model G Side View||Photo||English||44KB|
|Model G Top View||Photo||English||62KB|
|T&M Pressure Transducer Range Guide||Product Range Guide||English||1MB|
|T&M Overview Brochure||Brochure||English||413KB|
|Aerospace Test and Measurement Capabilities||Application Note||English||2MB|